Premigration administration
Issue 2.1 June 2006 763
Verifying administration and system status
You want to check which groups are administered before the migration and compare the list
after the migration to ensure that they are the same.
To verify administration and system status:
1. Execute the following commands to determine whether the system has administration and
system status:
a. list config all
b. list trunk
c. list sig
d. list station
e. list dial analysis
f. list vector
g. list vdn
h. list node-names
i. list ip-interfaces
j. display alias station
k. disp sync
l. status health
m. status spe
n. status pnc
o. status sync
If any command does not complete successfully, escalate the problem immediately. After
the migration, check the same administration to ensure that the translations are intact.
Recording all busyouts
To record busyouts:
1. Type display errors. Press Enter.
2. Look for type 18 errors and record any trunks that are busied out. You can return these
trunks to the busyout state after the migration/upgrade.
To Next Page
Loading...
