Avaya S8100 Series - Turning off the control chassis

Migrating an Avaya IP600/S8100 to an S8500 Media Server
594 Upgrading, Migrating, and Converting Media Servers and Gateways
Note:
Note: If you replace a TN795 Processor circuit pack, you might not need the TN744D/E
Call Classifier-Detector circuit pack. The TN2312BP IPSI circuit pack has call
classifier functionality. However, increased voice and data traffic can require the
TN744D/E Call Classifier-Detector circuit pack.
Note:
Note: If you have a TN799C or earlier CLAN circuit pack, you must replace the TN799
circuit pack with a TN799DP CLAN circuit pack.
Note:
Note: You must install the new Communication Manager license file on the media
server before you make the change or the system will not run.
Turning off the control chassis
To turn off the control chassis:
!
CAUTION:
CAUTION: Ensure that you have completed the premigration administration. For more
information, see Premigration administration
on page 846.
1. Press and hold the shutdown button on the on the faceplate of the processor until the
shutdown process starts.
Ensure that you see the green light. This light indicates that the system is shut down.
!
DANGER
:
DANGER: The latch on the power supply acts as the DC power switch and removes only DC
power from the backplane. To remove the AC power from the chassis, pull the AC
power cord from the back of the chassis.
2. To turn off the chassis, unplug the power cord from the back of the chassis.