Current configuration tasks:
Issue 2.1 June 2006 259
● Releasing MMI using SATon page 275
● Busying out previously busied out trunks on page 276
● Checking for translation corruption with SAT (main server only) on page 276
● Resolving alarms on page 276
● Backing up recovery system files on the active server on page 276
● Releasing alarm suppression on the media server (optional) on page 277
● Logging off all administration applications on page 277
● Disconnecting from the active media server on page 277
● Connecting to the standby media server on page 278
● Backing up files on the standby media server on page 278
● Releasing alarm suppression on the media server on page 278
● Logging off the administration applications on the standby media server on page 278
● Registering Avaya Communication Manager on page 279
Current configuration tasks:
Connecting to the active media server
If you are on site, connect to the services port on the back of the active media server.
If you are off site, log on to the active media server with the actual IP address of the media
server.
Starting a SAT session
To start a SAT session.
1. Open a terminal emulation application, such as MS HyperTerminal.
2. Type 192.11.13.6 5023 and press Enter.
3. Log on as craft or dadmin.
To Next Page
Loading...
