Migrating a DEFINITY Server SI Direct-Connect in an SCC to a Direct-Connect
488 Upgrading, Migrating, and Converting Media Servers and Gateways
Recording node names and IP addresses
To record node names and IP addresses:
1. Note the node names and the IP addresses that are assigned to the TN2302AP IP Media
Processor and the TN799C/DP C-LAN circuit packs. Ensure that these names and
addresses are the same after the migration.
Note:
Note: If the existing system has TN799C C-LAN circuit packs, you must replace these
circuit packs with TN799DP circuit packs.
2. To get the node names for the TN2302AP IP Media Processor and TN799C/DP C-LAN
circuit packs, type display ip-interfaces. Press Enter.
3. To get the IP addresses that match the node names, type list node-names. Press
Enter.
4. Record the information for use after the migration.
Saving translations
Although the migrated translations are already copied to the media server, you must save the
translations in case you need to back out of the migration.
Note:
Note: Save translations to a flash card.
To save translations:
1. To save translations to the system disk, type save translation. Press Enter.
Either a Command successfully completed The message displays or all error messages
are logged.
To Next Page
Loading...
Need help?
General
