Post-migration administration
Issue 2.1 June 2006 375
Using static addressing
You can administer static IP addresses for the SIPI circuit packs. You administer the addresses
directly through the Ethernet port connection on the SIPI faceplate (top port). For more
information, see Figure 4: Connecting directly to the SIPI
.
Figure 4: Connecting directly to the SIPI
Note:
Note: Ensure that you have the password before proceeding.
Clearing the ARP cache on the laptop computer
You might need to clear the Address Resolution Protocol (ARP) cache before you enter a new
IP address. This need depends on the operating system on your laptop computer. If you enter
an IP address and your computer cannot connect, you might need to clear the cache.
To clear the ARP cache on the laptop:
1. Click Start > Run to open the Run dialog box.
2. To open an MS-DOS command line window, type command. Press Enter.
Figure notes:
1. Services laptop
2. PCMCIA Network Interface Card (NIC)
3. NIC adapter cable (if necessary)
4. CAT5 crossover cable to SIPI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4
To Next Page
Loading...
