Upgrade tasks (first media server)
Issue 2.1 June 2006 175
Verifying software operation
To verify the software version.
1. Under Server, click Software Version.
2. Look in the Reports as field to verify that the new software is present.
Checking system status
To check the system status:
1. Under Server, click Status Summary.
2. Verify the following information:
● Standby Refreshed is set to Yes
● Standby Shadowing is set to On
● Duplication Link is set to Up
Releasing the standby media server
To release the media server from busyout mode:
1. Under Server, click Release Server.
2. To verify that the standby server is no longer busied out, click Status Summary.
Interchanging the media servers
To interchange the active and standby media servers:
Note:
Note: For Communication Manager Release 3.0 and earlier, interchanging the media
servers does not preserver calls. The Communication Manager reset is
equivalent to a reset system 4. However, if you are upgrading a Release 3.0.1
system and you performed the Pre Upgrade Step, most stable calls are
preserved. Unstable calls and DCS or SIP calls are dropped.
To Next Page
Loading...
