Premigration administration
Issue 2.1 June 2006 663
● Testing the installation on page 700
● Busying out previously busied out trunks on page 700
● Troubleshooting the migration on page 700
● Returning replaced equipment on page 700
Premigration administration
This migration affects service because you must turn off the cabinets to replace the Processor
and tone clock circuit packs. Before you turn off the cabinets, you must perform the following
premigration administration.
!
CAUTION:
CAUTION: The licensing of the platform and port network connectivity attributes for the
S8700-Series Media Server can be complex. See Caution about platform/PNC
license settings for the S8700-series Media Server on page 314 and License and
Avaya authentication files on page 313.
Connecting to the processor
To connect to the processor:
1. Connect the computer that you use to access the cabinet.
2. Start a SAT session using Native Configuration Manager or Avaya Site Administration.
3. Log in as craft.
Verifying system status
Check which groups are in- or out-of-service before the migration. After the migration, compare
the after the migration list with the before the migration list to ensure that the lists are the same.
To verify system status:
1. To determine whether the system has administration, run the following commands:
a. list configuration all
b. list trunk-group
c. list hunt-group
If any command does not complete successfully, escalate the problem immediately. After
the migration, check the same administration to ensure that the translations are intact.
To Next Page
Loading...
