Migrating hardware
Issue 2.1 June 2006 319
Migrating hardware
The information in this section is based on the assumption that the media server complex is
installed, configured, and operational.
DEFINITY Server CSI or DEFINITY ONE/S8100 in a CMC
When migrating an existing DEFINITY Server CSI or DEFINITY ONE in a CMC, you use the
TN8400AP S8400 Media Server circuit pack to control the PN. You replace the processor circuit
pack with the TN8400AP Media Server and TN8412AP S8400 IP Interface (SIPI) circuit packs
in the cabinet in the A position. Install the TN8400AP Media Server circuit pack in slot 1 and the
TN8412AP SIPI circuit pack in slot 2.
This migration affects service because you must turn off the CSI or DEFINITY ONE chassis to
replace the processor. Before you turn off the chassis, you must perform some premigration
administration.
Avaya IP600 in a G600
When migrating an existing Avaya IP600, you use the TN8400AP S8400 Media Server circuit
pack to control the PN. You replace the processor circuit pack with the TN8400AP Media Server
and TN8412AP SIPI circuit packs in the cabinet in the A position. Install the TN8400AP Media
Server circuit pack in slot 1 and the TN8412AP SIPI circuit pack in slot 2.
This migration affects service because you must turn off the IP600 chassis to replace the
processor. Before you turn off the chassis, you must perform some premigration administration.
Prerequisites for migrating to an S8400 Media Server
This section describes the following tasks that you must complete before you start the
migration.
● Tasks that you must perform before you go on site
● Tasks that you must perform on site before you start the migration from an existing
DEFINITY system
● Tasks that you must perform on site before you start the migration
● Documents that Avaya recommends that you have before you start the migration
To Next Page
Loading...
Need help?
General
