Issue 2.1 June 2006 1235
6. In the Configure Interfaces window, do the following steps:
● Enter the IP addresses of the duplication link port (Eth 2) on each server.
● Select AUTOSENSE for the speed.
Click Change to update the media server. When the screen shows
Successfully configured ethernet interfaces.
7. Click Close Window to close the Configure Server wizard.
Checking system status
To check the system status:
1. Under Server, click Status Summary.
2. Verify the following information:
● Standby Refreshed is set to Yes
● Standby Shadowing is set to On
● Duplication Link is set to Up
To Next Page
Loading...
