Migration tasks
Issue 2.1 June 2006 369
Verifying hardware
Ensure that you have the conversion specific hardware on hand.
Note:
Note: The TN8400AP Media Server circuit pack that contains the IA770 feature
replaces the TN798 or TN2402 Processor circuit pack that does not have that
feature. You must return the current processor circuit pack to Avaya.
Turning off the power to the control cabinet
!
CAUTION:
CAUTION: Ensure that you have completed the premigration administration. If you do not
perform the premigration administration, the system will not function. For more
information, see Migrating translations
on page 814.
To turn off power to the control cabinet:
1. On the faceplate of the processor, press and hold the shutdown button until the shutdown
process starts.
When you see the green light the system is shut down.
!
DANGER
:
DANGER: The latch on the power supply acts as the DC power switch and removes only DC
power from the backplane. To remove the AC power from the cabinet, pull the AC
power cord from the back of the cabinet.
2. Unplug the power cord from the back of the cabinet to turn off the cabinet.
Removing circuit packs
To remove circuit packs from the CMC:
1. Remove the TN798B or TN2402 Processor circuit pack from slot A01.
2. Remove the TN2182 Tone Clock circuit pack from slot A02.
3. Remove the TN767 DS1 Interface circuit pack, if installed.
4. Remove the TN2207 DS1 Interface circuit pack, if installed.
5. Remove the TN2313 DS1 Interface circuit pack, if installed.
To Next Page
Loading...
