On first S8720 Media Server
Issue 2.1 June 2006 987
4. On the Select Release Version window, ensure that the Build line and <OK> are
highlighted. Press Enter to partition the hard disk and reformat the partitions.
Once the drive is properly configured, the program starts the installation process and
reports the progress.
These processes can take up to 20 minutes. When the media server is ready to reboot, the
CD-ROM drive drawer opens. You must remove the CD from the drive at this time.
The reboot can take up to 3 minutes. The telnet session drops automatically.
Accessing the server command line interface with SSH protocol
Note:
Note: Using the SSH protocol to access the server is applicable to CM Release 3.0 and
forward.
To use this procedure with a laptop cable connection to the services port, you must configure
your laptop for the network connection. See Network configuration
on page 1242. In addition, a
third-party SSH client must already be installed on your computer.
PuTTY is one such client available for download from http://www.putty.nl/download.html
. The
following procedure describes, as an example of SSH access, how to log into the server
command line with PuTTY.
To Next Page
Loading...
