Upgrade tasks (first media server)
Issue 2.1 June 2006 163
5. Click Submit.
6. Click Status to view the Backup History.
Note:
Note: The backup status function for the Linux Migration is not enabled for Release
1.3.1. To check the backup status when you upgrade from Release1.3.1, under
Data Backup/Restore, select Backup Status. Then select the backup set and
click Check Status.
7. Select the box next to the file that is being backed up and click Check Status. When the
backup is complete, the system displays the following message:
Backup is finished
!
Important:
Important: Check the text to verify that no error messages exist.
Setting Telnet parameters
Note:
Note: Use a telnet session to access the information on the CD-ROM.
You can set the Microsoft Telnet application to send a carriage return (CR) and a line feed (LF)
whenever you press Enter. The installation program sees this single key press as two key
presses. If you are running Windows 2000 or Windows XP, you must undo this setting before
you copy the Remaster Program to the hard disk drive.
To configuring telnet for Windows 2000/XP, perform the following steps:
1. Click Start > Run to open the Run dialog box.
2. Type telnet and press Enter to open a Microsoft Telnet session.
3. Type display and press Enter to see the current settings.
To Next Page
Loading...
