Avaya S8100 Series - Recording node names and IP addresses; Migration tasks; Verifying hardware

Migration tasks
Issue 2.1 June 2006 395
Recording node names and IP addresses
To record node names and IP addresses:
1. Note the node names and the IP addresses that are assigned to the TN2302AP IP Media
Processor and the TN799C/DP C-LAN circuit packs. Ensure that these names and
addresses are the same after the migration.
Note:
Note: If the existing system has TN799C C-LAN circuit packs, you must replace these
circuit packs with TN799DP circuit packs.
2. To get the node names for the TN2302AP IP Media Processor and TN799C/DP C-LAN
circuit packs, type display ip-interfaces. Press Enter.
3. To get the IP addresses that match the node names, type list node-names. Press
Enter.
4. Record the information for use after the migration.
Migration tasks
You can reuse the translations from the current system when you migrate to an S8400 Media
Server.
Note:
Note: You must install the new Communication Manager license file on the media
server before you make the change. The SIPI serial number can be used for
licensing purposes.
Perform these tasks to convert a processor port network to a port network (CMC).
Verifying hardware
Ensure that you have the conversion specific hardware on hand.
Note:
Note: The TN8400AP Media Server circuit pack that contains the IA770 feature
replaces the TN798 or TN2402 Processor circuit pack that does not have that
feature. You must return the current processor circuit pack to Avaya.