Avaya S8100 Series - Migration tasks; Verifying hardware; Changing the IP600 control chassis to a port network

Migration tasks
Issue 2.1 June 2006 593
Migration tasks
Perform the following tasks to convert a processor port network to a port network (IP600).
Verifying hardware
Ensure that you have the conversion specific hardware on hand.
Note:
Note: Customers who currently use the Audix feature on the S8100 must purchase a
separate Audix system. The TN795 or the TN2314 Processor circuit pack that
contains the Audix feature is replaced with a TN2312BP Internet Protocol Server
Interface (IPSI) circuit pack that does not contain the Audix feature. You must
return the existing processor circuit pack to Avaya.
Note:
Note: Customers also must add an ED-1E568-70G1 DEFINITY Audix Slim board and a
TN2501AP Voice Announcement over LAN (VAL) circuit pack for
announcements.
Changing the IP600 control chassis to a port network
To change the Avaya IP600 control chassis to a port network, you must:
● Replace the existing straight-wire WP cables, if present, with new twisted pair I/O cables.
● Replace the processor circuit pack with a TN2312BP Internet Protocol Server Interface
(IPSI) circuit pack.
● Connect a CAT5 straight-through cable from the IPSI to the media server through the
network of the customer.