Converting some or all direct-connect port networks to IP-connect
1066 Upgrading, Migrating, and Converting Media Servers and Gateways
Disabling PNC duplication, if necessary
If the bearer network is duplicated, you must remove the duplication before you remove the
fiber-optic connections. If the system does not have PNC duplication, continue with Removing
fiber-related administration on page 1066.
To remove PNC duplication, log in to the SAT and complete these steps:
1. Enter status pnc to check which of the duplicated PNCs is active.
2. If the B-PNC is active, enter reset pnc interchange to make the A-PNC active.
3. Enter busyout pnc-standby to busyout the standby PNC.
4. Enter change system-parameters duplication to open the duplication screen.
5. In the Enable Operation of PNC Duplication? field, enter n and press Submit.
Removing fiber-related administration
Before you can use the IP connections, you must remove the fiber administration for each PN
that you are converting to IP-PNC.
Complete the following steps at the SAT to busyout and remove the fiber links for each PN that
you are converting to IP-PNC:
Tip:
Tip: To view the fiber link numbers and the endpoints, enter list fiber-link.
1. Enter busyout fiber-link n, where n is the link number for the fiber connection.
2. Enter remove fiber-link n.
3. Repeat steps 1
and 2 for each IP-PNC PN.
Enabling PNC duplication, if necessary
If the final configuration is a mixture of fiber-PNC and IP-PNC PNs and if the fiber- connect
portion is duplicated, you must enable PNC duplication.
To enable PNC duplication at the SAT:
1. Enter change system duplication to open the PNC Duplication screen.
2. Enter y in the Enable Operation of PNC Duplication? field and press Submit.
To Next Page
Loading...
