Migrating a DEFINITY Server CSI in a CMC to an S8500 Media Server
462 Upgrading, Migrating, and Converting Media Servers and Gateways
Migration tasks
You can reuse the translations from the existing system when you migrate to an S8500 Media
Server.
Note:
Note: You must install the new Communication Manager license file on the media
server before you make the change or the system will not run.
Verifying hardware
Ensure that you have the conversion specific hardware on hand.
Note:
Note: The TN798 circuit pack or the TN2402 Processor circuit pack that contains the
Audix feature is replaced with a TN2312BP Internet Protocol Server Interface
(IPSI) circuit pack that does not have the Audix feature. You must return the
existing processor circuit pack to Avaya.
Note:
Note: Customers also must add an ED-1E568-70G1 DEFINITY Audix Slim board and a
TN2501AP Voice Announcement over LAN (VAL) circuit pack for
announcements.
Changing the control cabinet to a port network
To change the control cabinet to a port network (PN):
1. Remove the TN798 or the TN2402 Processor circuit pack. Replace the TN2182 Tone Clock
circuit pack with a TN2312BP Internet Protocol Server Interface (IPSI) circuit pack.
2. Connect a CAT5 straight-through cable from the IPSI to the media server through the
customer network.
To Next Page
Loading...
Need help?
General
