Checklist for converting a port network to duplicated TN2602AP IP Media Resource 320 circuit packs
Issue 2.1 June 2006 1205
Instructions for converting a port network to duplicated
TN2602AP IP Media Resource 320 circuit packs
Checking your shipment, if not reusing existing TN2602AP circuit
packs
When the order arrives at your site, check the contents (see Table 23: Required Hardware on
page 1205).
1. Inspect the shipping carton for damage before opening it. If the box is damaged, do not
open it. Inform the shipping company, and ask for instructions on filing a claim.
2. If the box is undamaged, check the contents against the packing slip. Check the condition of
each component, and note any damage or shortages on the packing slip. The carton should
contain the items in Table 23: Required Hardware
on page 1205 for each TN2602AP IP
Media Resource 320 circuit pack ordered.
3. Read and follow any directions inserted into the package by the factory.
Note:
Note: The customer must provide one CAT5 or better cable for each TN2602AP.
In addition, a TN771DP maintenance test circuit pack is required in an IP-PNC PN that has both
duplicated control and duplicated bearer.
Table 23: Required Hardware
Comcode/
Code
Description Quantity
108566381 TN2602AP IP Media Resource 320
(MedPro)
1 or 2/PN
700283690 Media Resource 320 Adapter
1
with
retainer clip
1/MedRes
700234032
– 700207111
– 700181118
Migration kit (PEC code 63275):
2
– Upper circuit pack slot label
– Twisted pair I/O cables
1
10
3
1
The adapter has an amphenol connector on one side, an RJ45 connector
and 2 Ethernet ports on the other for connecting to the network. See Media
Resource 320 Adapter on page 1210.
2
Only if installing in old carriers or cabinets with WP cables.
3
Only one cable is needed for each circuit pack.
To Next Page
Loading...
