On first S8720 Media Server
Issue 2.1 June 2006 983
Connecting the cables to the first S8720 Media Server
To connect the cables to the media server:
Note:
Note: Do not connect the fiber duplication connection cable or the duplication interface
IP cable at this time to either S8720 Media Server
1. The network connections depend on the type of memory duplication and the type of control
network being used. Connect the network cables as described in the following table.
Control
Network
Software Memory Duplication Hardware Memory Duplication
Dedicated
● LAN to Eth4
(3rd from left on quad NIC)
● CNA to Eth2
(1st on left on quad NIC)
● CNB (if used) to Eth3
(2nd from left on quad NIC)
● LAN to Eth4
(3rd from left on quad NIC)
● CNA to Eth0
(on server, labeled 1)
● CNB (if used) to Eth3
(2nd from left on quad NIC)
Nondedicated ● LAN/CNA to Eth2
(1st from left on quad NIC)
● CNB (if used) to Eth3
(2nd from left on quad NIC)
● LAN/CNA to Eth0
(on server, labeled 1)
CNB (if used) to Eth3
(2nd from left on quad NIC)
To Next Page
Loading...
