Tasks to preserve connections when starting from R3.0.1 only (main server only):
Issue 2.1 June 2006 219
3. Type almsuppress -t time, where time is the length of time that the alarms are
suppressed up to 120 minutes (2 hours). Press Enter to suppress both dial-out and SNMP
alarms.
The system displays the following message:
Alarm is suppressed. 120 minutes left.
4. Log off and close the dialog box.
Tasks to preserve connections when starting from R3.0.1
only (main server only):
Disconnecting from the standby media server
If you are on site, unplug the laptop from the services port on the back of the standby media
server.
Connecting to the active media server
If you are on site, connect to the services port on the back of the active media server.
If you are off site, log on to the active media server with the actual IP address of the media
server.
Accessing the media server maintenance web interface
To access the media server:
1. Start the Web browser.
2. In the Address field, type 192.11.13.6. Press Enter to open the login Web page.
3. Log in as craft or dadmin.
To Next Page
Loading...
