Post-migration administration
Issue 2.1 June 2006 789
If reusing the EI circuit pack in a CSS:
3. Move the EI/ATM Interface circuit pack from location C02 to location A01.
4. If critical reliability, move the EI/ATM Interface circuit pack from location D02 to location B02.
If using ATM EIs:
5. Run the fiber optic cables for the expansion interface circuit packs through the media
gateway, using a cable pass-thru kit.
6. Connect the fiber optic cables to the connector on the front of the expansion interface circuit
packs. The LED lights up when properly connected.
Turning on the media gateway
To turn on the media gateway:
1. Turn on the media gateways.
2. Remove the emergency ground wire if used.
Post-migration administration
Accessing the server command line interface with SSH protocol
Note:
Note: Using the SSH protocol to access the server is applicable to CM Release 3.0 and
forward.
To use this procedure with a laptop cable connection to the services port, you must configure
your laptop for the network connection. See Network configuration
on page 1242. In addition, a
third-party SSH client must already be installed on your computer.
PuTTY is one such client available for download from http://www.putty.nl/download.html
. The
following procedure describes, as an example of SSH access, how to log into the server
command line with PuTTY.
Note:
Note: A version of PuTTY that is defaulted for SSH server access is available for Avaya
services personnel only. In this version, some values below have already been
pre-selected.
To Next Page
Loading...
