Migrating a DEFINITY Server SI Direct-Connect in an MCC to a Direct-Connect
538 Upgrading, Migrating, and Converting Media Servers and Gateways
Using static addressing
You can administer static IP addresses for the IPSI circuit packs. You administer the addresses
directly through the Ethernet port connection on the IPSI faceplate switch which is the top port
(Figure 23: Connecting directly to the IPSI
on page 538).
Figure 23: Connecting directly to the IPSI
Note:
Note: Ensure that you have the IPSI password before you continue.
Clearing the ARP cache on the laptop computer
You might need to clear the Address Resolution Protocol (ARP) cache before you enter a new
IP address. This need depends on the operating system on your laptop computer. If you enter
an IP address and your computer cannot connect, you might need to clear the cache.
To clear the ARP cache on the laptop:
1. Click Start > Run to open the Run dialog box.
2. To open an MS-DOS command line window, type command. Press Enter.
Figure notes:
1. Services laptop
2. PCMCIA Network Interface Card (NIC)
3. NIC adapter cable (if necessary)
4. CAT5 cross-over cable to IPSI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4
To Next Page
Loading...
