Checklist for converting a port network to duplicated TN2602AP IP Media Resource 320 circuit packs
Issue 2.1 June 2006 1217
Testing the external connection to the LAN
To test the external IP connections, ping a computer on the same subnet, the gateway, and a
computer beyond the gateway. If everything is configured correctly, the Result column on the
Ping Results screen reads pass. If it reads abort, verify the IP-address information and check
the connectivity, including the cabling.
1. Type ping ip-address ipaddress board UUCSS and press Enter, where ipaddress
is the IP address of the TN2602AP IP Media Resource 320 and UUCSS is the cabinet,
carrier, and slot location of a C-LAN circuit pack or another media processor circuit pack
within the subnet.
2. If step 1 passes, type ping ip-address ipaddress board UUCSS and press Enter,
where ipaddress is the IP address of an endpoint on the customer’s gateway and UUCSS
is the cabinet, carrier, and slot location of the TN2602AP circuit pack you are testing.
3. If step 2 passes, type ping ip-address ipaddress board UUCSS and press Enter,
where ipaddress is the IP address of an endpoint beyond the gateway and UUCSS is the
cabinet, carrier, and slot location of the TN2602AP circuit pack you are testing.
The TN2602AP IP Media Resource 320 circuit pack is now installed in the media gateway and
connected to the IP network.
Verifying active call status
To verify that calls are being processed:
1. Make an external trunk call to a telephone on the port network and leave the call active.
2. Type status media-processor board UUCSS, where UUCSS is the location of the
active circuit pack.
The Media Processor Status screen appears.
ping ip-address 192.168.10.38 board 02B05
PING RESULTS
End-pt IP Port Port Type Result Time(ms) Error Code
192.168.10.21 01A13 MEDRES PASS 10
To Next Page
Loading...
