S8500 Media Server
Issue 2.1 June 2006 299
Avaya IP600 in a G600
When migrating an existing Avaya IP600, you use the TN8400AP S8400 Media Server circuit
pack to control the PN. You replace the processor circuit pack with the TN8400AP Media Server
and TN8412AP SIPI circuit packs in the cabinet in the A position. Install the TN8400AP Media
Server circuit pack in slot 1 and the TN8412AP SIPI circuit pack in slot 2.
This migration affects service because you must turn off the IP600 chassis to replace the
processor. Before you turn off the chassis, you must perform some premigration administration.
S8500 Media Server
Use these procedures to migrate from existing DEFINITY systems to the Avaya S8500 Media
Server with limited out-of-service time. The existing systems must be standard reliability and
direct connect. You cannot migrate systems that use a center stage switch (CSS) or
asynchronous transfer mode (ATM). In all instances, the cabinets can be reused as port
networks (PNs). You do not need a G650 Media Gateway. However, you can add a G650 Media
Gateway PN if the existing system has only one or two port networks.
You can migrate the following existing systems:
● DEFINITY Server SI in a single carrier cabinet (SCC) or multicarrier cabinet (MCC). You
can migrate only the Direct-Connect configurations
● DEFINITY Server CSI in a compact modular cabinet (CMC). You can migrate only the
IP-PNC configurations
● DEFINITY ONE in a CMC. You can migrate only the IP-PNC configurations.
● Avaya IP600/S8100 in a G600. You can migrate only the IP-PNC configurations.
To Next Page
Loading...
