Converting some or all CSS port networks to IP-PNC
1096 Upgrading, Migrating, and Converting Media Servers and Gateways
Verifying IPSI translations
To verify IPSI translations:
1. Type list ipserver-interface. Press Enter.
2. Verify that the ISPI circuit pack(s) are translated.
The State of Health - C P E G column shows 0.0.0.0 for each healthy IPSI. If a "1" shows
in any position, you must troubleshoot the problem.
Tip:
Tip: The pattern 0.1.1.0 usually means that a cabinet type is administered
incorrectly or a connectivity problem exists, such as an incorrectly terminated
cable.
Verifying IPSI connectivity
To verify IPSI connectivity:
1. Under Diagnostics, click Ping.
2. Under Endpoints to Ping, select IPSIs with cab number (1–99) ___ carrier number ___.
3. Type the correct cabinet and carrier numbers in the text boxes.
4. Click Execute Ping.
5. Verify that the endpoints respond correctly.
Administering the media processor circuit pack
To administer the TN2602AP IP Media Resource 320:
1. From the active media server, log on to a SAT session.
2. To verify that the TN2602AP is correctly registered in the installed location, enter list
configuration board UUCSS.
3. Check the firmware version in the Vintage column. If the version is earlier than the latest
version that is available on the Avaya Support Web site, you must upgrade the TN2602AP
firmware.
4. To check the Maximum TN2602AP VoIP Channels field, enter display
system-parameters customer-options, and go to page 2.
To Next Page
Loading...
