Migrating from an S8700 Media Server to an S8710 Media Server
916 Upgrading, Migrating, and Converting Media Servers and Gateways
Configuring the network parameters
!
Important:
Important: If you backed up files to the services laptop, do not perform this procedure.
Continue with Selecting the media server type
on page 920.
Note:
Note: If you backed up to the network of the customer, you must readminister the
Ethernet port that connects to the network. You must have the host name, the IP
address, the subnet mask, and the default gateway for the two media servers and
the active server. You also need the IP address for the Ethernet port that
connects to the customer network.
To configure the network parameters:
1. Under Server Configuration, click Configure Server to open the first page and select the
server type of the Configure Server process.
The system displays the Configure Server window.
2. Select the appropriate server type and click Continue.
3. Click Continue through the Review Notices to get to the Specify how you want to use
this wizard page.
4. Select Configure individual services and click Continue.
5. Click Set Identities from the main menu.
6. On the Set Server Identities window:
a. Populate the Host Name fields.
b. In the This is server field, select 1.
c. Assign the Ethernet ports and click Continue.
7. In the Configure Ethernet Interfaces window, type the correct IP addresses, the gateway,
and the subnet mask or use the default addresses for the Ethernet port that is connected to
the customer LAN. Select AUTOSENSE for the speed.
● S8710 IP-PNC: Eth 0
● S8710 Fiber-PNC: Eth 4
Click Change to update and reboot the media server. When the system shows the message
Successfully configured ethernet interfaces, the Ethernet ports are configured.
8. Click Close Window to close the Configure Server wizard.
To Next Page
Loading...
