Migrating from an S8700 or S8710 Media Server to an S8720 Media Server
976 Upgrading, Migrating, and Converting Media Servers and Gateways
Obtaining the Product ID on the standby S8700 or S8710 Media
Server
Note:
Note: You might see different values for the product ID between the active and standby
media servers.
To obtain the Product ID:
1. Access the server command line interface.
2. Log in as craft or dadmin.
3. At the prompt, type productid. Press Enter.
The productid is the product ID you received from the customer or the ART too.
Looking up server configuration information on the standby
S8700 or
S8710 Media Server
Perform this task if you are backing up to the customer network.
To look up and record server configuration information:
1. Under Server Configuration, click Configure Server to open the first page (Select server
type) of the Configure Server process.
The system displays the Configure Server window.
2. Click Continue through the Review Notices to get to the Specify how you want to use
this wizard page.
3. Select Configure individual services and click Continue.
4. Click Set Identities from the main menu.
5. In the Set Identities area, record the following information for later use:
● Server number (from the This is server number field)
● Ethernet assignments (in the Select NIC Usage area)
6. Record the Ethernet port assignment and usage for each of the five possible interfaces. For
example, see Control Network A in Network Interface Card usage
on page 977. Notice that
CNA is assigned Ethernet 0.
Note:
Note: If these values are different from the defaults, physical connections to the
Ethernet ports must match these settings.
To Next Page
Loading...
