Migrating from a DEFINITY Server CSI in a CMC with an ATA Flash to an S8400 Media Server
364 Upgrading, Migrating, and Converting Media Servers and Gateways
You can reuse the translations from the existing system when you migrate to an S8400 Media
Server.
Note:
Note: You must install the new Communication Manager license file on the media
server before you make the change or the system will not run.
Perform these tasks to convert a processor port network to a port network (CMC).
Premigration administration:
● Connecting to the processor on page 365
● Removing netcon data modules on page 366
● Verifying system status on page 367
● Recording all busyouts on page 367
● Recording node names and IP addresses on page 367
● Saving translations on page 368
Migration tasks:
● Verifying hardware on page 369
● Turning off the power to the control cabinet on page 369
● Removing circuit packs on page 369
● Inserting circuit packs on page 370
● Connecting cables on page 370
● Replacing the TN799C C-LAN circuit pack on page 371
● Installing TN771 Maintenance/Test on page 371
● Installing the software load on page 372
● Configuring the media server on page 372
● Copying translation files to the media server on page 373
Post-migration administration:
● Using static addressing on page 375
● Clearing the ARP cache on the laptop computer on page 375
● Logging in to the SIPI on page 376
● Setting the control interface on page 376
● Resetting the SIPI on page 378
● Enabling control of the SIPI on page 379
To Next Page
Loading...
