Upgrading Communication Manager from 1.x to 3.1 on an S8300 Media Server
82 Upgrading, Migrating, and Converting Media Servers and Gateways
21. If the S8300B LSP’s
translations have not
synchronized with the primary
controller, invoke translation
synchronization.
● On the primary controller, enter the Linux
command filesync -a trans.
● Ensure that the translation synchronization
completed successfully.
Wait several minutes, then check the
timestamp of the LSP’s translation files
using the SAT command list
survivable-processor on the primary
controller.
22. Upgrade G700 Media
Gateway firmware
See "Upgrade the firmware on
the G700 Media Gateway" in
Chapter 11.
Using the Avaya Installation Wizard:
● Upgrade G700 firmware
● Upgrade media module firmware
23. Set Rapid Spanning Tree
See "Setting rapid spanning
tree on the network" in Chapter
11.
Post-upgrade tasks
24. Implement any additional
design changes to voice and/
or voice messaging networks.
25. Re-register the S8300B (LSP
mode only) with the Avaya
servicing center.
Task Steps/Comments
5 of 5
To Next Page
Loading...
