Tasks checklist
Issue 2.1 June 2006 81
ICC mode: On LSPs of the S8300B (if any)
16. Reboot LSPs (if any) At the LSP’s SAT prompt, enter reset system
4.
17. Verify LSP translations date
and time (if any).
To view the LSP’s translations date and time,
enter list configuration software.
ICC mode: On the S8300B
18. Verify LSP status (if any)
● At the ICC’s SAT prompt, enter list
survivable-processor.
The LSP name and IP address should be
listed.
● The Translations Updated should match
the translations date and time on the ICC.
To view the ICC’s translations date and
time, enter list configuration
software.
19. If the LSPs (if any) translations
have not synchronized with the
ICC, invoke translation
synchronization.
● On the ICC, enter the Linux command
filesync -a trans.
● Ensure that the translation synchronization
completed successfully.
Wait several minutes, then check the
timestamp of the LSP’s translation files
using the SAT command list
survivable-processor on the ICC.
LSP mode: On the S8300B’s primary controller
20. Verify S8300B LSP status (if
any)
● At the primary controller’s SAT prompt,
enter list survivable-processor.
The S8300B LSP name and IP address
should be listed.
● The Translations Updated should match
the translations date and time on the
primary controller. To view the primary
controller’s translations date and time,
enter list configuration software.
Task Steps/Comments
4 of 5
To Next Page
Loading...
