Upgrading Communication Manager from 1.x to 3.1 on an S8300 Media Server
80 Upgrading, Migrating, and Converting Media Servers and Gateways
9. Disable RAM disk and reboot.
See "Disabling RAM disk on
the media server" and "Reboot
the media server" in Chapter
11.
ICC Mode only: RAM disk must be disabled in
order to successfully restore translations.
10. Restore data
See "Restoring data" in
Chapter 11.
Select the restore procedure according to the
release from which you upgraded.
● ICC Mode: Restore Translations and
AUDIX files, if used.
● LSP Mode: No data restore required.
11. Enable RAM disk and reboot.
See "Enabling RAM disk on
the media server" and "Reboot
the media server" in Chapter
11.
ICC Mode only: RAM disk must be manually
enabled after you restore translations.
12. Set time, date, and time zone.
See "Verifying the time, date,
and time zone" in Chapter 11.
ICC Mode: The time zone of the new ICC must
be set, and all LSPs under the ICC’s control must
be set to the new ICC’s time zone.
LSP Mode: The time of the LSP must be set to
the same time zone as its primary controller,
even if the LSP is physically located in a different
time zone.
13. Install license file.
See "Installing the new license
file" in Chapter 11.
14. Install authentication file.
See "Installing the new
authentication file, if any" in
Chapter 11.
15. Verify that the media gateway
has registered with either the
primary controller (LSP mode)
or the S8300B (ICC mode).
● Open a SAT session with either the
primary controller (LSP mode) or the
S8300B (ICC mode) and enter list
media-gateway.
Verify that the Registered field (Reg?) is set
to y.
● Place a test call.
Task Steps/Comments
3 of 5
To Next Page
Loading...
