Conversion Tasks
Issue 2.1 June 2006 1057
You can install the media processor and the CLAN circuit packs in any universal port slots.
However, for SCC1 and MCC1 carriers, you must place the media processors in the slots that
the EI circuit packs formerly occupied.
You must place the IPSI circuit packs in the slots that are specified in the following table.
IPSI slot locations
Carrier or Gateway
Slot Number
Primary Secondary, if duplicated
control, for S8700 series
only
G650 stack A01 B01
SCC1 EPN A00 B01
MCC1 EPN containing one PN
● Tone Clock slot
(A00)
B01
MCC1 EPN containing two PNs
● Tone Clock slot
(A00)
● E02
B01
D01
MCC1 EPN containing three
PNs
● Tone Clock slot
(A00)
● B02
● D02 (single control)
● E02 (duplicated
control)
Control duplication is not
supported with three PNs.
D01 (duplicated control)
MCC1 EPN containing four PNs
● Tone Clock slot
(A00)
● B02
● C02
● D02 (single control)
● E02 (duplicated
control)
Control duplication is not
supported with four PNs
D01 (duplicated control)
MCC1 EPN containing five PNs
● Tone Clock slot
(A00)
● B02
● C02
● D02
● E02
Control duplication is not
supported with five PNs
To Next Page
Loading...
