Introduction
Issue 2.1 June 2006 1155
On the LSP’s primary controller
19. Remove endpoints that
will be controlled by
the new ICC from the
current primary
controller.
● Remove users/endpoints from the current
primary controller.
On the new ICC
20. Verify that the media
gateway has
registered with the
ICC.
● Open a SAT session and enter list
media-gateway. Verify that the
Registered field (Reg?) is set to y.
● Place a test call.
On LSPs of the new ICC (if any)
21. Reboot LSPs (if any) At the LSP’s SAT prompt, enter reset system
4.
22. Verify LSP translations
date and time (if any).
To view the LSP’s translations date and time,
enter list configuration software.
On the ICC
23. Verify LSP status (if
any)
● At the SAT prompt, enter list
survivable-processor(for CM R3.1)
or list lsp (for CM R2.x). The LSP
name and IP address should be listed.
● The Translations Updated date and time
should match the translations date and
time on the primary controller. To view the
primary controller’s translations dates and
times, enter list configuration
software-version.
24. If the LSPs (if any)
translations have not
synchronized with the
ICC, invoke translation
synchronization.
● On the ICC, enter the Linux command
filesync -a trans.
● Ensure that the translation synchronization
completed successfully. Wait several
minutes, then check the timestamp of the
LSP’s translation files using the SAT
command list
survivable-processor or list lsp
on the ICC.
Task Steps/Comments
To Next Page
Loading...
