Avaya S8100 Series - Page 1175

Checklist
Issue 2.1 June 2006 1175
Figure 89: IP Node Names screen
2. In the Name column, type the name of the LSP.
3. In the IP Address column, type the IP address of the LSP.
4. At the SAT command line, type add survivable-processor <name>, where <name>
is the LSP name from the Node Names screen.
The Survivable Processor screen appears.
Figure 90: Add Local Survivable Processor screen
5. The type field is automatically populated with LSP. LSP appears in the field if the node
name is not associated with ESS.
change node-names ip Page 1 of X
IP NODE NAMES
Name IP Address Name IP Address
1. ______________ ___.___.___.___ 17. ______________ ___.___.___.___
2. ______________ ___.___.___.___ 18. ______________ ___.___.___.___
3. ______________ ___.___.___.___ 19. ______________ ___.___.___.___
4. ______________ ___.___.___.___ 20. ______________ ___.___.___.___
5. ______________ ___.___.___.___ 21. ______________ ___.___.___.___
6. ______________ ___.___.___.___ 22. ______________ ___.___.___.___
7. ______________ ___.___.___.___ 23. ______________ ___.___.___.___
8. ______________ ___.___.___.___ 24. ______________ ___.___.___.___
9. ______________ ___.___.___.___ 25. ______________ ___.___.___.___
10. ______________ ___.___.___.___ 26. ______________ ___.___.___.___
11. ______________ ___.___.___.___ 27. ______________ ___.___.___.___
12. ______________ ___.___.___.___ 28. ______________ ___.___.___.___
13. ______________ ___.___.___.___ 29. ______________ ___.___.___.___
14. ______________ ___.___.___.___ 30. ______________ ___.___.___.___
15. ______________ ___.___.___.___ 31. ______________ ___.___.___.___
16. ______________ ___.___.___.___ 32. ______________ ___.___.___.___
add survivable-processor sv-mg2-lsp Page 1 of xx
SURVIVABLE PROCESSOR - PROCESSOR ETHERNET
Node Name: sv-mg2-lsp
IP Address: 128.256.173.101
Type: LSP
Network Region: 1