Checklist for converting a port network to duplicated TN2602AP IP Media Resource 320 circuit packs
Issue 2.1 June 2006 1215
2. In the Critical Reliable Bearer? field, type y, and press Enter.
A second column of data for a standby TN2602AP appears on the right of the screen.
3. Complete the following fields.
● The Type, Slot, IP Address, and Code/Suffix fields for the active circuit pack are
populated automatically.
● In the Node Name field, type the same node name entered on the Node Name screen.
● In the Subnet Mask field, enter the subnet mask determined by the LAN administrator.
This setting also applies to the second TN2602AP circuit pack when Critical Reliable
Bearer is y.
● In the Gateway Address field, use the address determined by the LAN administrator.
This setting also applies to the second TN2602AP circuit pack when Critical Reliable
Bearer is y.
● Set the Enable Ethernet Port field to y.
● Set the Net Region field to 1 or another number determined by the LAN administrator.
This setting also applies to the second TN2602AP circuit pack when Critical Reliable
Bearer is y.
● Set VLAN to n.
● Set the VOIP Channel field to 80 or 320, depending on the number of circuit packs that
are licensed for each, and the capacity the customer needs for this port network. This
setting also applies to the second TN2602AP circuit pack when Critical Reliable Bearer is
y.
add ip-interface 1a03 Page 1 of 1
IP INTERFACES
Critical Reliable Bearer? y
Type: MEDPRO
Slot: 01A03 Slot:
Code/Suffix: TN2602 Code/Suffix:
Node Name: medpro03a01 Node Name:
IP Address: 192.168.1.82 IP Address:
Subnet Mask: 255.255.255.0
Gateway Address: . . .
Enable Ethernet Port? y Enable Ethernet Port? y
Network Region: 1
VLAN: n VLAN: n
VOIP Channels: xxx
Shared Virtual Address: 255.255.255.255
Virtual MAC Table: Virtual MAC Address:
ETHERNET OPTIONS
Auto? n Auto? n
Speed: 100 Mbps Speed: 100 Mbps
Duplex: Full Duplex: Full
To Next Page
Loading...
