Upgrade tasks (second media server)
Issue 2.1 June 2006 187
Because the software upgrade destroyed the configuration data, you must configure the
network parameters before restoring the backup files.
1. Under Server Configuration click Configure Server to open the first page.
2. Click Continue through the Review Notices to get to the Specify how you want to use
this wizard page.
3. Select Configure individual services and click Continue.
4. Select Configure Interfaces from the menu on the left.
5. Fill in the following data for the Ethernet port, which can be Eth 0 for IP-PNC and Eth 4 for
fiber-PNC:
● The IP address
● The Gateway
● The Subnet mask (or use the default addresses)
6. Select AUTOSENSE for the speed. Click Change to update and reboot the media server.
When the screen displays
Successfully configured the ethernet interfaces.
the Ethernet ports are configured.
7. Click Close Window to close the Configure Server wizard.
To Next Page
Loading...
