Migrating from an IP600 or S8100 to an S8400 Media Server using ftp
422 Upgrading, Migrating, and Converting Media Servers and Gateways
The general migration procedures are as follows:
● Turn off the processor gracefully - pre-conversion administration
● Replace the processor circuit pack or tone clock circuit pack with a TN8412AP S8400 IP
Interface (SIPI) circuit pack
● Connect the SIPI circuit pack to the Ethernet switch on the customer network
● Assign an IP address to the SIPI circuit pack
You can reuse the translations from the existing system when you migrate to an S8400 Media
Server.
Note:
Note: You must install the new Communication Manager license file on the media
server before you make the change. The SIPI serial number can be used for
licensing purposes.
Perform these tasks to convert a processor port network to a port network (CMC).
Premigration administration:
● Connecting to the processor on page 424
● Saving translations on page 424
● Verifying system status on page 424
● Recording all busyouts on page 425
● Recording node names and IP addresses on page 425
Migration tasks:
● Verifying hardware on page 426
● Opening a SAT session on page 426
● Copying translation files on page 426
● Opening an ftp session on page 427
● Moving the translation files on page 427
● Turning off power to all cabinets on page 427
● Removing circuit packs on page 428
● Inserting circuit packs on page 428
● Connecting cables on page 428
● Replacing the TN799C C-LAN circuit pack on page 429
● Installing TN771 Maintenance/Test on page 429
● Setting telnet parameters on page 430
● Installing the software load on page 430
To Next Page
Loading...
