Contents
48 Upgrading, Migrating, and Converting Media Servers and Gateways
Configuring the SNMP modules in the UPS. . . . . . . . . . . . . . . . . . 1168
Configuring the SNMP subagent in the Avaya Ethernet switch . . . . . . . 1168
Disabling the boot timeout of the SAMP board (S8500B upgrade only). . . 1168
Installing Avaya Communication Manager . . . . . . . . . . . . . . . . . . 1169
Configuring the S8500 LSP. . . . . . . . . . . . . . . . . . . . . . . . . . . 1171
Configuring the RMB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1172
Installing SAMP software update, if necessary . . . . . . . . . . . . . . . . 1173
Configuring the modem. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1174
Administering the new primary controller. . . . . . . . . . . . . . . . . . . 1174
Enable license server capability on a media gateway, if necessary. . . . . 1176
Install and verify the license on the new LSP . . . . . . . . . . . . . . . . . 1176
Opening the TCP ports on the S8500 LSP. . . . . . . . . . . . . . . . . . . 1177
Connect the new S8500 LSP to the LAN/WAN . . . . . . . . . . . . . . . . 1179
Reset the S8500 LSP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1179
Verify that the primary controller identifies the new LSP and has
sent the translations. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1179
Readminister the desired media gateways to point to the LSP . . . . . . . 1180
Converting IP-PNC port networks with simplex control to
duplicated control . . . . . . . . . . . . . . . . . . . . . . . . . . . 1181
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1181
Preconversion assumptions . . . . . . . . . . . . . . . . . . . . . . . . . . . 1181
Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1182
Installing and cabling a second Ethernet switch, if necessary . . . . . . . 1182
Configuring the SNMP subagent in the Avaya Ethernet switch (if used) . . 1183
Enabling firewall settings, if necessary . . . . . . . . . . . . . . . . . . . . 1185
Accessing the media server maintenance web interface. . . . . . . . . . . 1186
Configuring Control Network B . . . . . . . . . . . . . . . . . . . . . . . . 1186
Designating the slot for the duplicated IPSI circuit pack. . . . . . . . . . . 1188
Installing the duplicated IPSI circuit pack. . . . . . . . . . . . . . . . . . . 1189
Adding control network cabling for the new circuit pack . . . . . . . . . . 1197
Verifying the IPSI circuit packs are inserted properly . . . . . . . . . . . . 1197
Programming the duplicated IPSI circuit pack . . . . . . . . . . . . . . . . 1197
Starting a SAT session . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1199
Administering the duplicated IPSI circuit pack on the media server . . . . 1199
Verifying IPSI translations . . . . . . . . . . . . . . . . . . . . . . . . . . . 1200
Upgrading IPSI firmware, if necessary. . . . . . . . . . . . . . . . . . . . . 1200
To Next Page
Loading...
