Migrating a DEFINITY Server SI Direct-Connect in an MCC to a Direct-Connect
524 Upgrading, Migrating, and Converting Media Servers and Gateways
● Replace the tone clock circuit pack and Maintenance circuit pack with an IP Server
Interface (IPSI) circuit pack and new maintenance circuit pack, respectively
● Replace old expansion interface circuit packs with new expansion circuit packs, if
necessary
● Connect the IPSI circuit pack to the Ethernet switch on the customer network
● Assign an IP address to the IPSI circuit pack
You can reuse the translations from the existing system when you migrate to an S8500 or
S8700-Series Media Server.
Perform the following tasks to convert a processor port network to a port network (MCC).
Premigration administration:
● Connecting to the processor on page 526
● Verifying system status on page 526
● Recording all busyouts on page 526
● Recording node names and IP addresses on page 527
● Saving translations on page 527
Migration tasks:
● Accessing the media server maintenance web interface on page 528
● Verifying the license file on page 528
● Copying translation files to media server on page 528
● Restoring translation files on page 529
● Administering the IPSIs on page 529
● Adding IPSI translations to Communication Manager on page 530
● Setting the alarm activation level on page 530
● Backing up translations on page 531
● Verifying hardware on page 531
● Removing the processor port network control carrier on page 531
● Installing the expansion control carrier on page 532
● Installing IPSI and maintenance circuit packs on page 533
● Connecting the CAT5 cables to the IPSI circuit packs on page 535
● Installing Expansion Interface circuit packs on page 535
● Turning on the media gateway on page 536
To Next Page
Loading...
