Migration paths
Issue 2.1 June 2006 623
Be sure to do this step
before freezing translations.
Verify that the CMS and
INTUITY peripherals and
Distributed Communication
Service (DCS) links are
assigned node names and
an Ethernet address.
Be sure to do this step
before freezing translations.
Remove all Mode II Data
Modules before you change
the S8700-Series Media
Server.
The S8700 and the S8710 do not support the following
data modules:
● System Ports
● PDMs (7400/8400 Data Modules)
● PktGateway
● Pkt Data Dataline
● Modem Pool
● System CDR PDMs
● System Features Printer PDMs
Be sure to do this step
before you freeze
translations.
The TN750 Announcement
circuit packs are not
supported in the
S8700-Series Media
Servers.
The announcements translations migrate to the
S8700 Series Media Server. However, you must
change the circuit pack locations to the TN2501AP
Voice Announcement over LAN (VAL) circuit pack.
NOTE:
All announcement names must be unique on a
TN2501AP VAL circuit pack. The announcement
names cannot contain any spaces, blanks, or the
following characters:
● forward slash (/)
● colon (:)
● asterisk (*)
● question mark (?)
● backward slash (\)
● angle brackets (<>)
Type change announcements to change any
names and port locations.
9
Task Description
2 of 4
To Next Page
Loading...
