Migration tasks
Issue 2.1 June 2006 845
● Connect the IPSI circuit pack to the Ethernet switch on the network of the customer
● Assign an IP address to the IPSI circuit pack
Note:
Note: You must install the new Communication Manager license file on the media
server before you make the change or the system will not run.
Perform the following tasks to convert a processor port network to a port network (IP600).
Premigration administration:
● Connecting to the processor on page 847
● Recording node names and IP addresses on page 847
● Saving translations on page 848
● Recording IP settings on page 848
Migration tasks:
● Accessing the media server maintenance web interface on page 849
● Checking system status on page 849
● Verifying the license file on page 849
● Restoring data for a migration (S8710 only) on page 850
● Adding IPSI translations to Communication Manager on page 852
● Adding IPSI information on page 852
● Setting IPSI duplication (high-reliability critical-reliability only) on page 853
● Setting the alarm activation level on page 853
● Backing up translations on page 853
● Verifying hardware on page 854
● Changing the IP600 control chassis to a port network on page 854
● Turning off the control chassis on page 855
● Replacing I/O cables on page 855
● Replacing the processor circuit pack on page 858
● Replacing the TN799C C-LAN circuit pack on page 858
● Installing TN771 Maintenance/Test circuit pack on page 859
● Connecting to the media server on page 859
Post-migration administration:
● Accessing the server command line interface with SSH protocol on page 859
To Next Page
Loading...
