On first S8720 Media Server
Issue 2.1 June 2006 997
3. Select Configure all services using the wizard. Click Continue.
4. On the Set Identities page, under the Select Server Duplication area, select either:
● This is a duplicated server using duplication hardware
● This is a duplicated server using software-based duplication
● This is a duplicated server using encrypted software-based duplication
Note:
Note: The physical connections to the Ethernet ports are different for hardware
duplication and software duplication. For more information, see Connecting the
cables to the first S8720 Media Server on page 983.
5. Click Continue.
Note:
Note: The following step applies only if you are using software duplication.
6. On the Configure Interface page, set the speed for Ethernet 0: Server Duplication Link to
either:
● AUTO SENSE
● 1 Gigabit full duplex
7. Click Continue through all the screens, checking for new screens and new fields on
existing screens as mentioned in the Software Release Letter.
Note:
Note: You must click through all the screens whether there are changes or not.
8. On the Configure ESS window:
● If the server is a primary control main, click This is NOT an enterprise survivable
server
● If the server is an ESS server, click This is an enterprise survivable server (ESS)
9. Click Continue.
10. When you complete all the new fields, as necessary, click Continue on the Update System
screen. The Update System screen shows each configuration task as the task completes.
When done, the screen shows the line All configuration information was entered.
11. Click Close Window to close the Configure Server wizard.
12. Disconnect from the media server.
To Next Page
Loading...
