NEC Univerge SV9100 - Page 14

vi Table of Contents
Issue 3.0
10.1.2 Install Cooling Fan ..................................................................... 3-115
Chapter 4 Installing the SV9100 Blades
Section 1 General Information................................................................................. 4-1
1.1 Slot Locations.................................................................................. 4-1
Section 2 Installation ............................................................................................... 4-4
2.1 Installation and Safety Precautions................................................. 4-4
2.2 Installing an Extension or Trunk Blade............................................ 4-5
2.2.1 Installing the Blades ...................................................................... 4-5
2.2.2 Order of Installing Extension Blades.............................................. 4-6
2.2.3 Order of Installing Trunk Blades .................................................... 4-7
2.2.3.1 Installing GCD-4COTB, GCD-4DIOPA, GCD-4ODTA or
GCD-2BRIA Blades ..................................................................4-7
2.2.3.2 Installing GCD-PRTA (T1/PRI) Blades .....................................4-8
2.3 Remove an Extension or Trunk Blade ............................................ 4-8
2.4 Uninstalling a Blade Slot Through Software.................................... 4-9
2.5 Blade Capacities ............................................................................. 4-9
2.6 Powering Up the SV9100 System................................................... 4-9
2.6.1 Performing a Cold Start ................................................................. 4-9
2.6.2 Performing a Hot Start................................................................. 4-10
2.6.3 Resetting the System................................................................... 4-10
2.6.3.1 Initial Programming.................................................................4-10
2.6.3.2 Port Defaults ...........................................................................4-11
2.6.3.3 Setting Up Extension Circuit Types ........................................4-11
2.6.3.4 Saving Your Configuration......................................................4-11
2.6.3.5 Backing Up/Restoring a Database..........................................4-12
2.6.4 Performing a Software Upgrade .................................................. 4-13
Section 3 Common Control Blades....................................................................... 4-15
3.1 GCD-CP10 (SV9100 Central Processing Unit) ............................. 4-15
3.1.1 Description................................................................................... 4-16