Converting S8300 ICC mode to LSP mode
1160 Upgrading, Migrating, and Converting Media Servers and Gateways
3. Reassign endpoints from
the ICC to this primary
controller.
For information on
updating translations, see
the Administrator Guide
for Avaya Communication
Manager, 03-300509.
● Update translations — add stations and trunks.
- If the primary controller is a new installation, using
the Avaya Installation Wizard and the Electronic
Pre-Installation Worksheet (EPW) is
recommended
- Alternatively, use SAT commands.
● Place test calls to verify.
● Reassign IA770 users to the messaging system
used by this primary controller. Enter test
messages to verify.
On the DHCP server
4. Update the alternate
controller list on the
DHCP server.
See "Considerations for
IP Phones Supported by a
Local Survivable
Processor" in Chapter 9.
On the gateway’s MGP
5. Telnet to the MGP and
change gateway’s
controller list.
See "Setting up the
controller list for the
G700" in Chapter 9.
● Clear the gateway’s controller list.
● Enter the IP addresses of the primary controller
and up to three alternate controllers.
● Set the LSP transition points.
● If the media gateway is a G350, enter:
copy running-config startup-config
● Reset MGP
Task Steps/Comments
2 of 5
To Next Page
Loading...
