Avaya S8100 Series - Page 1162

Converting S8300 ICC mode to LSP mode
1162 Upgrading, Migrating, and Converting Media Servers and Gateways
11. Install post-conversion
service pack file, if any.
See "Installing
post-upgrade
Communication Manager
service pack file from your
laptop, if any" in Chapter
12.
12. Install the LSP license file.
See "Installing the
updated license file" in
Chapter 12.
13. Install the authentication
file.
See "Installing the
updated license file" in
Chapter 12.
14. Configure server.
See "Configuring the
S8300" in Chapter 9.
● Fill in each Configure Server screen with data for
the LSP. Some of the configuration data will be the
same as that for the ICC.
● On the Configure Local Survivable Processor
screen, select the LSP choice and the IP address
to which the LSP should register.
15. Reboot the LSP.
● Open a SAT session and enter reset system
4.
After the reboot, the LSP should be registered with
the primary controller and in a few minutes
translations should be synchronized.
Task Steps/Comments
4 of 5