Migration tasks
Issue 2.1 June 2006 495
Figure 12: Ribbon cable connector
5. Push the tabs on the ends of the connector inward to lock the connector in place.
6. Thread the ribbon through the slot on the front panel (Simplex reliability ribbon cable
connection on page 496).
7. Insert the TN775D Maintenance (EPN) circuit pack part way into the MAINTENANCE slot.
8. Attach the other end of the short ribbon cable to the top connector on the component side of
the TN775D Maintenance (EPN) circuit pack with the red line on the bottom (Simplex
reliability ribbon cable connection on page 496).
caxxinst LJK 022002
To Next Page
Loading...
