Avaya S8100 Series - Page 674

Migrating from a DEFINITY Server SI in an SCC to an S8700-Series Media Server with Fiber-PNC
674 Upgrading, Migrating, and Converting Media Servers and Gateways
Figure 38: Ribbon cable placement with the pass-through tool
13. Plug the long ribbon cable into the bottom connector on the component side of the TN775D
Maintenance (EPN) circuit pack. The red line is on bottom (Figure 39: High-reliability and
critical-reliability ribbon cable connection on page 675).
14. Push the tabs on the ends of the connector inward to lock the connector in place.
15. Thread the ribbon cable through the remaining slot on the faceplate of the TN775D
Maintenance (EPN) circuit pack.
16. Route the cable through the TDM slot in the back of the SCC1 media gateway A and up to
SCC1 media gateway B (Cable routing through the TDM slot
on page 676).
C
L
K
S
E
R
V
I
C
E
N
E
T
W
O
R
K
A
L
A
R
M
S
E
M
E
R
T
R
M
A
J
M
IN
W
R
N
AC
K
ON
OFF
AUTO
cadsrib2 KLC 032602
602