Migrating translations
Issue 2.1 June 2006 783
12. Attach the other end of the short ribbon cable to the top connector on the component side of
the circuit pack. The red line must be on the bottom) See Duplex reliability ribbon cable
connection on page 781.
13. Push the tabs on the ends of the connector inward to lock the connector in place.
14. Thread the ribbon through the slot on the front panel.
15. Fully insert the TN2312BP Internet Protocol Server Interface (IPSI) circuit pack only.
16. Assign the Switch and Cabinet ID to the TN2312BP Internet Protocol Server Interface (IPSI)
just inserted. See Using DHCP addressing
on page 791.
17. Type set tone-clock cabinet carrier. Press Enter to force a tone clock
interchange.
18. Type status port-network number. Press Enter where number is the number of the
port network to verify the service state of the tone clock. Verify that the yellow LED on the
IPSI circuit pack is flashing.
19. Remove the TN2182 Tone Clock circuit pack from the new standby carrier (B). Place the
circuit pack in an antistatic carrier.
20. Insert the TN2312BP Internet Protocol Server Interface (IPSI) circuit pack part way into the
TONE-CLOCK slot on the standby carrier (B).
21. Attach one end of the long ribbon cable to the connector on the component side of the
circuit pack. The red line must be on the bottom (pin 1).
22. Push the tabs on the ends of the connector inward to lock the connector in place. See
Ribbon cable connector
on page 780.
23. Thread the ribbon through the slot on the front panel.
24. Attach the other end of the long ribbon cable to the bottom connector on the component
side of the TN775D Maintenance (EPN) circuit pack. The red line must be on the bottom.
See High-reliability or critical reliability ribbon cable connection
on page 784.
25. Fully insert the TN2312BP Internet Protocol Server Interface (IPSI) circuit pack.
26. Program the TN2312BP Internet Protocol Server Interface (IPSI) just inserted. See Using
DHCP addressing on page 791.
27. Fully insert the TN775D Maintenance (EPN) circuit pack after both IPSIs have been
programmed.
To Next Page
Loading...
