Upgrading Communication Manager from 2.x to 3.1 on an S8300 Media Server
88 Upgrading, Migrating, and Converting Media Servers and Gateways
LSP mode: On the primary controller of the S8300B
13. Verify S8300B LSP status
(if any)
● At the SAT prompt, enter list
survivable-processor. The LSP name and
IP address should be listed.
● The Translations Updated date and time should
match the translations date and time on the
primary controller. To view the primary
controller’s translations dates and times, enter
list configuration software-version.
14. If the S8300B LSP’s
translations have not
synchronized with the
primary controller, invoke
translation
synchronization.
● On the primary controller, enter the Linux
command filesync -a ipaddress
where ipaddress is the IP address of the LSP.
● Ensure that the translation synchronization
completed successfully. Wait several minutes,
then check the timestamp of the LSP translation
files using the SAT command list
survivable-processor on the primary
controller.
15. Upgrade G700 Media
Gateway firmware
See "Manually upgrading
G700 firmware" in
Chapter 12.
Using the Avaya Installation Wizard:
● Upgrade G700 firmware
● Upgrade media module firmware
16. Set Rapid Spanning Tree
See "Setting rapid
spanning tree on the
network" in Chapter 12.
Post-upgrade tasks
17. Implement any additional
design changes to either
or both voice networks
and voice messaging
networks.
18. Reregister the S8300B in
LSP mode with the Avaya
servicing center.
Task Steps/Comments
4 of 4
To Next Page
Loading...
