Tasks
Issue 2.1 June 2006 87
6. Install the updated license
and authentication files
See "Install updated
license and authentication
files" in Chapter 12.
7. Save Translations
See "Saving translations"
in Chapter 12.
8. Verify that the media
gateway has registered
with either the primary
controller (LSP mode) or
the S8300B (ICC mode).
● Open a SAT session with either the primary
controller (LSP mode) or the S8300B (ICC mode)
and enter list media-gateway.
Verify that the Registered field (Reg?) is set to y.
● Place a test call.
ICC mode: On LSPs of the S8300B (if any)
9. Reboot LSPs (if any) At the LSP’s SAT prompt, enter reset system 4.
10. Verify LSP translations
date and time (if any).
To view the date and time of the LSP translations, enter
list configuration software.
ICC mode: On the S8300B
11. Verify LSP status (if any)
● At the SAT prompt, enter list
survivable-processor. The LSP name and
IP address should be listed.
● The Translations Updated must match the
translations date and time on the ICC. To view
the date and time of the ICC translations, enter
list configuration software.
12. If the LSPs (if any)
translations have not
synchronized with the
ICC, invoke translation
synchronization.
● On the ICC, enter the Linux command
filesync -a trans.
● Ensure that the translation synchronization
completed successfully.
Wait several minutes. Then check the timestamp
of the LSP translation files using the SAT
command list survivable-processor on
the ICC.
Task Steps/Comments
3 of 4
To Next Page
Loading...
