On first S8720 Media Server
Issue 2.1 June 2006 981
To install the DAL1 card in the S8720 Media Server:
1. Lift up on the hood latch handle and remove the access panel.
Note:
Note: Always wear an antistatic wrist strap when working inside the media server.
2. Lift the PCI riser cage thumbscrews and turn them counterclockwise to loosen them.
3. Remove the PCI riser cage.
4. Remove the blank expansion slot cover from the PCI riser cage (3, Installing the DAL1
card on page 981).
Figure 66: Installing the DAL1 card
5. Unlock the PCI retaining clip (1).
6. Carefully insert the DAL1 card into the middle slot of the PCI riser cage (4).
7. Lock the PCI retaining clip (2).
8. Align the PCI riser cage with the guides on the chassis and slide the riser cage into place.
h3df87di LAO 110205
DAL1
DUP
MEMORY
RECEIVE
MODE
LINC
SYNC
TRANS
MODE
LINC
ACTIVE
1
2
3
4
To Next Page
Loading...
